Topic: Staircase Spindles
Not finding your answer? Try searching the web for Staircase Spindles
Answers to Common Questions
How to Paint Staircase Spindles
Staircase spindles are commonly made of either wrought iron or wood. Painting your staircase spindles should prove to be an easy task for those with a few spare hours. Use a high-quality metal primer and paint for metal spindles. If you're ... Read More »
Source: http://www.ehow.com/how_5895094_paint-staircase-spindles.html
How to replace spindles on staircase bannisters?
Step 1: Find the height of the baluster. You'll want the replacement baluster to be a couple inches longer than the measurement because it's easier to trim a piece down than make it longer. Step 2: Purchase a wooden baluster that matches yo... Read More »
Source: http://uk.answers.yahoo.com/question/index?qid=20090607030036AAcz...
What is the maximum distance between spindles on a staircase?
Code requirement for preparation for straight spindles of 4", contoured spindles the maximum spacing at the contours would be 4". Read More »
Source: http://www.chacha.com/question/what-is-the-maximum-distance-betwe...
More Common Questions
Answers to Other Common Questions
clean the wood first. then prime with an oil based stain blocking primer. it will stink so open the windows.if you dont use a stain blocking primer, the mahogany stain will keep coming through your paint. you CAN use water based paint/ enam...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20090324023511AAv7TD9
When occasionally stuck in that circumstance, I used a profile sander to get into tight spots. I would do what I can with an orbital sander, and complete the rest between the profile sander and hand sanding. The profile sander does save a...
Read More »
Source: http://en.allexperts.com/q/Cabinets-Furniture-Woodworks-1468/2008...
Stop at the landing. Look at the banister in front of you. See those letters carved into the bottom of the spindles? Guess what? You have to rotate the spindles accurately in order to get the correct message to spell out: D I E G O This puz...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20061015132318AAPXa2w
Measure the existing ones. You will find that there is a long and a short spindle for each tread. The spindle bottom section can be trimmed , but,most turned spindles are set so that the bases are the same length & the tapered ends on top a...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20071012210518AAqoAtX
go to hardware store and buy some mimwax wood conditioner. its made so that when you apply it it gives you a good even coat without accepting to much on the end grain. it coats the wood but will still accept the stain. try it on some sample...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20070709211052AAm0zYs
If you've never used a paint sprayer, don't try it now. At least not for this project. And the glove or paint mitt ideas sound like a recipe for disaster to me. Unfortunately, there is no easy way to paint spindles. Get a couple of rolls of...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20070711021828AA34gx7
If there is a bottom rail the spindles sit on: Measure the run (post to post, horizontally not along the slope). Divide that meas., in inches, by 3 inches. You want to come up with an even number and this may take some trial and error math....
Read More »
Source: http://answers.yahoo.com/question/index?qid=20070827141832AAuPiSi
