Topic: Truck Won't Accelerate
Answers to Common Questions
Why Won't my Truck Start?
There could be any number of problems, start off checking your battery. Try to jump it, if that doesn't work it's probably your starter. Read More »
Source: http://answers.ask.com/Sports/Racing/why_won't_my_truck_start
How to Adjust the Accelerator Cable in a GM Truck
GM trucks are popular vehicles and can be found driving the streets all across the world, most of the trucks running the popular Chevrolet V8 engine. Sometimes the accelerator pedal can become sticky or the accelerator cable can get stretch... Read More »
Source: http://www.ehow.com/how_5665011_adjust-accelerator-cable-gm-truck...
Why won't my truck accelerate?
First culprit would be fuel filter, second would be test fuel pressure, third would be check timing (old belts sometimes slip instead of breaking) Third would be check coil for break down in power feed then check distributor,cap rotor wires... Read More »
Source: http://answers.yahoo.com/question/index?qid=20090912134101AAHwP65
Answers to Other Common Questions
Main cause is fuel in your system so your fuel pump might be getting old and not pumping enough fuel into the chainbers, also replace the spark plugs in your vehicle would be a good thing, buy a bottle of fuel injection cleaner, when almost... Read More »
Source: http://wiki.answers.com/Q/What_are_the_possible_causes_when_a_tru...
well if it shakes after you accelerate that does not soound normal. it could have a bad air filter or maybe low on oil but if this F-150 still has the warrity than i would take it to the ford dealer ship and have them look at it. cause ther... Read More »
Source: http://wiki.answers.com/Q/Why_does_the_truck_shake_at_the_end_whe...
the accelerator pump is the left side of the carberator or passenger side of the truck you see the link from the throttle cable hooked to it ,it has plunger shaped rubber on it an can be taken out by the two philps screws in about 10 minute... Read More »
Source: http://wiki.answers.com/Q/Where_is_the_accelerator_pump_on_a_1986...
The function of the accelerator pump is to momentarily provide the additional quantity of fuel needed during acceleration. Read More »
Source: http://www.chacha.com/question/what-is-the-accelerator-pump-in-a-...
need to adjust high speed jet in carberator, turn in all the way then back out about 1 turn out and go from there. Read More »
Source: http://wiki.answers.com/Q/Why_stihl_chainsaw_won't_accelerate
Ignition is most likely culprit, plugs, wires, cap, etc - engines that run smooth at idle but break down under load again are usually ignition related. Year / model / engine would help determine where to start... I'd be looking into ignitio... Read More »
Source: http://wiki.answers.com/Q/When_you_start_to_accelerate_your_truck...
Check For binding of the controls in the throttle linkage at the carburetor or throttle body (fuel injection vehicle). It is critical to have free play of the linkage in those areas. If binding is in fact noticed there,, spray some WD-40 (o... Read More »
Source: http://wiki.answers.com/Q/How_do_you_fix_a_sticking_accelerator_i...
Want A Personal Answer?
733,157 people are answering.
About - Privacy - AskEraser - Advertise - Careers - Ask Blog - iPhone - Android - Help - Feedback ©2012 Ask.com