Topic: Use Pipe Dope on a Compression Fitting
Not finding your answer? Try searching the web for Use Pipe Dope on a Compression Fitting
Answers to Common Questions
What are Copper Pipe Compression Fittings?
Copper pipe compression fittings are devices used in plumbing when two tubes composed of different materials need to be joined and kept tight to avoid leaking. As the name suggests, these fittings work by compressing the two pipes together.... Read More »
Source: http://www.ehow.com/how_5040501_removing-copper-pipe-compression-...
How Are Copper Pipe Compression Fittings Removed?
The first thing that must be done to remove a copper pipe compression fitting is to unscrew the compression nut. Oftentimes the compression nut may have become corroded, making turning it near impossible without damaging the pipe. Remove th... Read More »
Source: http://www.ehow.com/how_5040501_removing-copper-pipe-compression-...
How to Fit Poly Pipe Connector Compression Sprinkler
Polyethylene, or poly pipe, is one of the most common types of tubing used in sprinkler systems. Poly pipe is affordable, flexible and easy to install. It also withstands high water pressure, and resists cracking or splitting. When using po... Read More »
Source: http://www.ehow.com/how_8008959_fit-pipe-connector-compression-sp...
More Common Questions
Answers to Other Common Questions
Compression fittings for copper water pipes usually connect appliances that will eventually need replacing, such as toilets or refrigerators. They are easy to install and to remove. They work by compressing a brass ferrule against both the ...
Read More »
Source: http://www.ehow.com/how_6162635_seal-fittings-copper-water-pipes....
I am a Plumbing/HVAC Contractor and the type of fitting I always used for underground copper service pipe has been 3/4" (standard size for residential) brass flared fittings. A flared connection is a tight, secure connection guaranteed not ...
Read More »
Source: http://wiki.answers.com/Q/What_type_of_compression_fittings_can_b...
I saw that too and questioned it. Seems like it would defeat the principle of a compression fitting. Might have some merit if the original fitting was being reinstalled after being taken apart which is what may have been the situation with ...
Read More »
Source: http://www.askmehelpdesk.com/plumbing/ask-old-house-episode-using...
Answer compresion fittings usually work well if u have any problems use some sealing tape Answer If you are going to have the pipes in wall use solder, any copper exposed youcan use compression.
Read More »
Source: http://wiki.answers.com/Q/When_working_with_copper_pipes_are_comp...
There are not a lot of tube fittings used in the USA with metric dimensions. Tube fittings are usually designed to MATCH the the tubing pressure rating class. My suggestion is to check out Parker Hannifin's websites as they are a major manu...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20090603083859AA5h8un
They do make a ferrel puller to remove the old compression fitting. Is it for a toilet or other supply line where you an angle-stop/supply shut off at? If you don't want to spend money on a puller, which can run about 40 bucks, if you have ...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20100315170725AA2IqZX
No need to wait at all..as long you have a good, snug seals on your pipe connections...you are good to go...there is no harm in teflon taping first and then pipe doping the threads..the extra few seconds may pay off in the long run...good j...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20080131164820AAiYnSG
