Topic: Using SWR Meter
Not finding your answer? Try searching the web for Using SWR Meter
Answers to Common Questions
How to Use an SWR Meter for a 2 Meter Radio
Standing Wave Ratio (SWR) meters are used to measure the efficiency of an antenna and cable. The antenna cable and antenna length should match the transmitter's output requirements. All antennas and cables operate with some loss and an SWR ... Read More »
Source: http://www.ehow.com/how_5928520_use-swr-meter-meter-radio.html?re...
How to Operate a SWR Meter
An SWR meter is used to measure how well your antenna and transmission line are matched to your transmitter. SWR is an abbreviation for standing wave ratio. An SWR meter works by measuring the ratio of the amount of transmitter power that i... Read More »
Source: http://www.ehow.com/how_6501349_operate-swr-meter.html
How to Work an SWR Meter
In the realm of radio communications, which includes CB and ham radio as well as others, it is important for you to be able to measure the amount of radio-frequency (RF) energy being reflected back toward your radio transmitter during opera... Read More »
Source: http://www.ehow.com/how_5946683_work-swr-meter.html
More Common Questions
Answers to Other Common Questions
The first step in learning how to use an ohm meter is to plug the test leads into the sockets. If necessary, zero the meter. Touch one probe to one end of the circuit, and another probe to the other end. Pick either 1000 or 10,000 ohm range...
Read More »
Source: http://answers.ask.com/Consumer_Electronics/Other/how_to_use_an_o...
A volt meter measure voltage. To hook one up first you need to connect the probes. After turning it on you touch the red probe to your positive. Then you touch the negative with the black probe. The reading should appear on the screen. To f...
Read More »
Source: http://answers.ask.com/Consumer_Electronics/Other/how_to_use_a_vo...
Using a voltage meter is relatively easy. First you connect the probes. Then turn it on. After you verify that it is on you touch the positive probe to the positive side and the negative probe to the negative side. To find more information ...
Read More »
Source: http://answers.ask.com/Consumer_Electronics/Other/how_to_use_a_vo...
Don't mean to be a smarta-- here, but a ph meter measured ph. In other words, it measured to measure the acidity of certain types of liquid.
Read More »
Source: http://answers.ask.com/Science/Physics/what_is_a_ph_meter_used_fo...
Using a light meter is easy to do. You only need to understand a couple of things about light meters. One is reflective metering and the other is incident metering. Once you know about these things, you will be able to use your meter just l...
Read More »
Source: http://answers.ask.com/Consumer_Electronics/Other/how_to_use_a_li...
The SWR meter or VSWR (voltage standing wave ratio) meter measures the standing wave ratio in a transmission line
Read More »
Source: http://www.chacha.com/question/what-does-swr-meter-do
The SWR meter has the same connectors as your CB radio's antenna cable contnector. So you use a very short piece of antenna connector cable to hook it up between the CB and the antenna. You use as short a piece as you can since even the cab...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20090918101029AAFfbG0
