Topic: Woodruff Key
Not finding your answer? Try searching the web for Woodruff Key
Answers to Common Questions
How to Remove a Woodruff Key
1 Use a penetrating oil to loosen any corrosion which may have the pulley seized to the shaft . 2 Remove the threaded fastener that holds the pulley in place . 3 Brush or lightly sand the shaft if there is rust or dirt built up on it . The ... Read More »
Source: http://www.wikihow.com/Remove-a-Woodruff-Key
What is Woodruff key?
( ′wu̇·drəf ′kē ) (design engineering) A self-aligning machine key made by a side-milling cutter in the form of a segment of a disk. Read More »
Source: http://www.answers.com/topic/woodruff-key
What does the woodruff key look like?
a small metal rectangle ( example 1/4" x 1/4" x 1 long ) that locks a wheel or pulley from rotating on a shaft. Read More »
Source: http://wiki.answers.com/Q/What_does_the_woodruff_key_look_like
Featured Content:
Woodruff Key
(n.) Key having the form of a nearly semicircular disk fitting into a recess in a shaft
Dictionary.com . See all 1 definitions »
More Common Questions
Answers to Other Common Questions
The 5.3 liter Vortec Engine on the 2000 Chevy Silverado has a tapered crank shaft. The crank pulley has no woodruff key, is not indexed and is pressed on.
Read More »
Source: http://wiki.answers.com/Q/Why_is_there_no_woodruff_key_on_crank_p...
With dial calipers, my closest estimate for the key size on a b2200 1987 to 199? is 3/4 inch in length, and width 190, height 240 to 250, I find that 230 is not tall enough, you may even want to check to be sure you have clearance behind th...
Read More »
Source: http://wiki.answers.com/Q/What_size_woodruff_key_is_in_a_1989_maz...
Plan A: Drive down the side closest to the base plate with a large pin punch and a heavy hammer or small sledge. This will drive up the top side of the key. Keep in mind the the key sits in a slot that is the exact same shape as the key its...
Read More »
Source: http://wiki.answers.com/Q/How_do_you_remove_a_frozen_woodruff_key...
Answer If the crank shaft is in the engine and if the engine is in the car I would put the car up on jack stands ( for safety). Remove the water pump pulley. That will allow you to remove the v-belt easily. Remove the plastic mud shield on ...
Read More »
Source: http://wiki.answers.com/Q/How_do_you_remove_a_broken_woodruff_key...
Dealer only item, take the vin# with you. How many valves got bent? Just the intakes? Source(s): Mitsubishi Master Tech
Read More »
Source: http://answers.yahoo.com/question/index?qid=20110115100623AAPQAMz
the crankshaft key? after the pulley is off, take dikes (wire cutters) and grip the key at the base, then pry it up. Just like you would if you had a hammer prying up a nail.
Read More »
Source: http://www.fixya.com/support/t3147095-remove_woodruff_key_from_19...
