Even parity and odd parity both refer to asynchronous communication parity checking modes; even parity sets an extra bit to 1 if the data item already has an odd number of "1" bits or to 0 if the number of "1" bits is even, while odd parity checking does the same but leaves the number of "1" bits odd. Parity bits are used to detect errors in devices that store memory.Know More
Here's an example of odd parity. The transmitted message 01000000 has only one "1" in it. Converting this to odd parity adds a zero, which yields 0 01000000. The total number of "1" digits in the message remains one, which is an odd number. If a message is 10101100, that message has four 1s in it, giving an even number. Turning it into odd parity adds a "1" at the start, yielding 1 10101100.
With even parity, the results would have been reversed. The first message (01000000) would have a "1" added, yielding 1 01000000. The second message (10101100) already has an even number of "1" bits, to the parity message would be 0 10101100.
Both receiver and sender must agree to use parity checking and whether to go with even or odd methodology.Learn more about Computer Programming
The difference between megabytes and gigabytes is the number of bytes that make up each unit and the amount of data they hold. A megabyte holds a million bytes, or about 1,000 kilobytes. A gigabyte holds about a billion bytes, or around 1,000 megabytes.Full Answer >
The Environmental Protection Agency defines a brownfield as land or buildings, typically in urban areas, the further use of which may be hampered by the presence of pollution or contaminants. Greenfields are areas available for development on the edges of urban areas or in suburban locations.Full Answer >
A DSS - or decision support system - is designed to provide effective analysis relevant to specific situations while an MIS - management information system - is designed for the efficient processing of data or information. As such, they are generally used by different people in different situations.Full Answer >
While there is not much difference between firmware and software in terms of how the different programs are coded, the terminology is typically used differently in terms of its applications in computers. While software generally refers to externally obtained and implemented programs that aid in improving the user-computer interface and user productivity, firmware is usually implemented in the computer at the time the hardware is put into place.Full Answer >