The steps to programming a remote from Pioneer vary between models. The basic operation includes holding down the remote's main setup button before entering the specific manufacturer code of the TV or device in question.Know More
Turn on the TV. The first programming scenario begins by entering Set Mode by pressing down both the CATV and the TV button for three seconds until the remote's LED light flashes repeatedly. Repeat this step if the light stops flashing. Once the light begins to flash, press down on only the CATV button until the light stays on. Press "0, 0, 2, 5" in that order until the LED light blinks twice and turns off. Enter Set Mode again and press CATV. Then, enter the manufacturer codes until the TV turns off. For unknown codes, turn the TV on and enter Set Mode. Press TV before pressing one of the remote's up arrow buttons slowly and repeatedly until the TV turns off.
For the following programming instructions, Device button refers to the TV, VCR and AUD buttons, while device refers to TVs, VCRs, DVD players and audio equipment. DVD players are programmed to the VCR button, while audio equipment is programmed to the AUD button.
For universal models that are designed to work with complete home theater systems, begin by turning on the device. Press and hold the Setup button until the LED light comes on, then off. Release the Setup button and proceed when the LED light blinks once. Press the Device button before entering the manufacturer codes until the LED light blinks twice. Press the Device button to turn the device off to ensure the operation worked correctly. For unknown codes, repeat the operation, but instead of entering the manufacturer codes, press Select slowly and repeatedly until the device turns off. Then, press the Device button to save the code.Learn more about Television & Video
To program a Magnavox universal remote control, find and enter the four-digit code that connects your remote to your television. If you don't have access to four-digit codes, you can perform a code search to program the remote.Full Answer >
Program your Samsung remote control using the Mode button or the appropriate buttons on the device. Some universal Samsung remotes have buttons for cable boxes, DVD players and other electronics, while others have a Mode button with a menu for selecting the correct device.Full Answer >
The U-verse Easy Remote app allows users to turn an iPhone, iPad or Android device into a remote control for a U-verse digital TV receiver. As of 2015, there are a number of U-verse-enabled apps that allow users to connect to and control U-verse digital TV receivers.Full Answer >
Programming a DISH Network remote control requires users to enter the proper remote control code for the additional unit or units that the remote will operate. There are three ways to program the DISH Network code into the remote.Full Answer >