To hotwire a Chevy truck, the panel covering the ignition system and steering column should be unscrewed and removed. The screws are usually located directly underneath the steering wheel. Next, the wires that are connected to the ignition system must be disconnected. Strip the two red wires, and connect them together. Next, strip the brown wires, and connect them together, when the engine starts disconnect the brown wires.Know More
The ignition system works as a switch with 2 modes. When the key is turned one notch (or two notches in cases of cars with steering wheel locks), the red wires are connected, completing the power circuit and providing electricity to the car. When the key is turned to the second mode, this connects the two brown wires together. The brown wires are part of the circuit for the starter motor. When they are connected, the power circuit that was completed by the first notch is fed to the starter motor. The starter motor turns the engine, which pulls fuel in to the cylinders. The spark plugs are also given power, as the sparks ignite the fuel in the cylinder, and the recurring explosion of fuel pushes the piston.
The starter motor should be disconnected when the engine starts. The internal combustion starts a chain reaction which keeps fuel flowing into the engine, powering the spark plugs and providing repetitive combustion inside the cylinders. The pistons are pushed by the explosion, and the resulting kinetic energy is used to drive the wheels, and in many cases the alternator. The alternator is an electricity generator that is turned by the engine, and as it turns, it charges up the car's battery.Learn more about Car Parts & Maintenance
To replace a car’s ignition switch, one must remove the steering column, disconnect the wiring, test the switch, and install the new switch, according to DoItYourself. This task requires a replacement ignition switch, a test light, a screwdriver, a ratchet, wires and wrenches.Full Answer >
The neutral safety switch is located either in the steering column or next to the gear shift lever. The location depends on where the display is for the gear selection.Full Answer >
Commonly, a key does not turn in its ignition if the steering column is jammed or the car is not in park. Other reasons for the car key not turning include the ignition lock cylinder being clogged with dirt, the key being damaged or the ignition being broken, according to Stu's EZ Auto Remotes.Full Answer >
In order to replace a turn signal switch the steering column must be removed, the battery disconnected and the unit replaced. The task is relatively simple to complete, but requires a basic understanding of the car's electrical system.Full Answer >