Q:

How does a car dynamo work?

A:

A car dynamo converts mechanical energy into electrical energy. The dynamo uses a coil of metal wire rotated within a magnetic field to convert the mechanical energy into direct current using Faraday’s law.

There are three main parts to the dynamo. The stator is the main housing unit, where the magnetic field is kept constant. The armature is the metal coils that are rotated by mechanical force. The commutator is a set of contacts on the armature’s shaft which reverses the electrical potential in the metal wire with every half turn of the armature, converting alternating current into direct current. In modern times, alternating current is mainly used because it is so easily converted by solid state materials.

The electric generator, which became the dynamo, was created by Michael Faraday in 1831. It began as a copper disc that was rotated between magnets. It is not considered a dynamo because it did not utilize a commutator. It did, however, create very low amounts of electric due to the single current path through a magnetic field. Faraday, with the help of others, discovered that more voltage could be created by winding multiple turns of a wire into a coil. The amount of voltage produced depends on the amount of turns. The dynamo eventually led to the invention of the electrical generators used today. Hand-cranked dynamos are still used today in handheld devices, such as hand-cranked radios, flashlights and watches. There are even hand-cranked dynamos that connect to mobile phones via USB.


Is this answer helpful?

Similar Questions

  • Q:

    How does an oxygen sensor in a car work?

    A:

    The oxygen sensor is positioned inside in the exhaust pipe, and it is used to detect rich or lean mixtures. This sensor is an essential component in the emissions control system, and it transmits data to the engine's computer. The primary function of the oxygen sensor is to help the engine operate as smoothly as possible by detecting the appropriate air-to-fuel ratio and using fuel efficiently.

    Full Answer >
  • Q:

    Why won't a car turn over but the lights and radio work?

    A:

    If a car will not turn over but the lights and radio still work, the problem is either a bad starter motor or a faulty ignition switch. A clicking noise when turning the key usually indicates a problem with the starter motor. No clicking sound and no sound from the engine can indicate a bad ignition switch. In both cases, the solution is to replace the faulty items.

    Full Answer >
  • Q:

    Why does my car heater not work?

    A:

    A car's heater does not generate heat if the coolant level is low or restricted by buildup, if the water pump failed or if the thermostat is broken. The heater fan is also sometimes an issue.

    Full Answer >
  • Q:

    How does a car immobiliser work?

    A:

    A car immobiliser disables one of the systems needed to start a car's engine, usually the fuel supply or the ignition. This is accomplished by RF identification between a transponder in the ignition key and a device called a RF reader in the steering column. The transponder sends a signal with a unique identification code to the reader, which relays it to a receiver in the vehicle's computer control module.

    Full Answer >

Explore