The ABS light in a Ford Explorer comes on and stays on when there is a problem with the brake system or in cases where spark plugs are wearing thin. This light indicates there is an issue with stopping power that generates issues when trying to stop rapidly or in bad weather. An ABS light sometimes comes on just before engine failure but coincides with all lights turning on.Know More
The antilock brake system or ABS is in charge of ensuring that the brake system does not lock up when trying to stop rapidly or in an emergency situation. In the old days, drivers needed to flutter the brakes or pump them to avoid locking. Modern systems do this automatically when the brake is depressed quickly and completely.
The ABS light in a Ford Explorer comes on and stays on in instances where this systems is not working. This occurs when the system shorts out or stops working altogether. This is an electrical interface and therefore relies on spark plugs and other solutions that generate power and maintain electronic systems. The ABS light indicates the system is offline, the sparks are dying or that the signal responsible for transmitting information between the system and the dash lights is wet.Learn more about Brakes
The ABS light comes on whenever there is a fault in the anti-lock braking system in a vehicle. The fault can be a low amount of fluid in the ABS reservoir to an electrical malfunction in the wheel speed sensor, control unit or the pump, but regular braking function is unaffected. Repair involves testing or replacing control unit and pump, the wheel speed sensors or power cycling the entire system.Full Answer >
There can be several reasons for the ABS light coming on in a car, including an electrical fault. Low fluid levels can also trigger the light.Full Answer >
To troubleshoot ABS problems on a Ford vehicle, first cycle the engine to rule out a passing glitch. Then, inspect the fuses, the ABS controller and the wheel speed sensors. If necessary, take the vehicle into a Ford dealership for an ABS controller scan.Full Answer >
To reset an ABS warning light, drain the electrical system of the car, or replace the ABS sensor if the brake system is working properly or has been recently serviced. Alternatively, check if the brake system parts need replacement or repair using an OBD code reader.Full Answer >