Installing an RV sofa is a process that can take several hours depending on your ability to work with furniture and tools and whether or not the existing furniture needs to be removed. In order to install an RV sofa, you need measuring tape, a wrench, a screwdriver and a hammer.Know More
Examine the area of the RV where the couch is to be installed and the piece of furniture you are preparing to install. Using your measuring tape, make sure that you have a properly sized piece of furniture for the RV space. If you attempt to install a sofa without a proper amount of room, you may damage your vehicle.
Using your wrench, remove the bolts that hold the existing sofa to the RV. If there are any screws, remove them with your hammer and screwdriver.
Align the new sofa so that it's directly over the area the old sofa used to cover. Before doing anything else, make sure that the holes in the base of this sofa match up with the pre-drilled holes that you originally removed the bolts from. Once everything is lined up, use your wrench to reapply the bolts to the sofa and fix it to the floor.
When a submarine implodes, the fittings and pipes give way as the intense water pressure crushes the hull, similar to the process of a fist crushing an egg or a lemon. All of the people inside die in a matter of seconds.Full Answer >
Cleaning the outside of a mobile home is a process that takes a variable amount of time depending on the severity of the dirt and the size of the home. In order to clean the outside a mobile home, you need a pressure wand, water, liquid soap, rags and vinegar.Full Answer >
Removing shrub roots is a process that depends on the quality of the soil and the tools used. Removing the shrub with a gardening tool is easier when the soil is loose. The project possibly requires the use of shovels, hoes and saws. Shrubs with more extensive root systems require chemical treatment.Full Answer >
The process of dyeing leather begins with applying deglazer to remove the shiny finish and stains from the surface of the leather. Spray a light mist of water to wet the leather before dye is applied using a cotton dauber or a soft-bristled scrub brush, and leave it to dry.Full Answer >