You can remove a front or rear bumper by removing the screws and corner bolts located on the inside of the bumper. Most car bumpers can be removed using a similar method regardless of the vehicle's make and model.Know More
Park the vehicle in a spacious and well-lit area. Be sure the engine is off. If your vehicle has a manual transmission, make sure it is in gear. Jacks or lifts may not be necessary, but if you need to raise the automobile to ensure better access, use caution, and make sure the vehicle is securely lifted.
Ways to disable airbags vary by manufacturer, so you should consult your manual. However, some basic steps are to disable the car battery, remove the steering wheel cover plate, and remove the wire connections with a screwdriver.
Open the hood. For either bumper, locate a small row of screws on the inside of the bumper. The front side may have a plastic shield to protect the radiator held in by the same screws; remove these screws as well. Store the screws in a safe place. The front bumper may have other clips or bolts, which must also be removed.
The front and rear bumpers usually have single bolts on the inside of each corner. Remove them, and the bumper should come loose. If not, check overlapping body panels and inside the trunk in the rear for additional screws, and remove them.
To clean the inside of a windshield, wipe it with a microfiber towel sprayed with glass cleaner. It might take more than one wiping to get rid of all streaks.Full Answer >
As cars grow older, they often develop many rattles; however, if the rattle is coming from the front of the engine along with ticks and slaps, it sometimes indicates a loose timing chain. If the chain breaks, it causes serious damage to the engine, according to About.com.Full Answer >
If your car squeaks while you drive, if the squeaking noise is coming from the front, it could be low steering wheel fluid. If the squeaking occurs when the car is stopping, the brake pads may need replacing. A squeal during acceleration most likely means a worn-out fan belt.Full Answer >
To remove a dent in a chrome bumper, remove the bumper from the vehicle, soften and heat the metal, and place a silicone mat and block of wood over the dent. Tap the wood with a mallet, and then check the smoothness of the dent.Full Answer >