To program a Viper door, you need to open a door first, and turn the ignition. Press and hold the Valet button. Finally, program the remote.
- Open a door
You need to open only one door of your vehicle to begin programming your Viper remote. Whichever door you choose, ensure that the dome light comes on after the door has been opened.
- Turn on the ignition
Place the key into the vehicle's ignition, and turn it on to the Run position labeled on the ignition.
- Press the Valet button
On the Viper remote, press the Valet button once to begin programming the channel of your choosing. Then, press the Valet button one more time. If this was done successfully, you should hear a mild honk, or see your LED lights flash.
- Hold the Valet button
After you have been signaled by your vehicle that it has programmed the channel, press and hold the Valet button.
- Program your remote
Continue holding the Valet button, and press the button on the transmitter that you wish to have programmed on the remote. If successful, you will hear another honk, or your LED lights will glow. Repeat this step if you wish to perform additional programming. You can now release the Valet button you were pressing. Your Viper remote is now programmed with your vehicle.