A leak on an exhaust manifold can be welded, or depending on the severity of the damage, result in having the unit replaced. Small cracks are patchable, but large cracks require more extensive repair.Know More
The exhaust system begins at the manifold. When the manifold is damaged, the engine sounds louder, releases poisonous gas into the air and often results in poor fuel economy.
Small cracks can be welded shut. Although this is still considered a temporary fix, proper technique will extend the lifetime of the weld. The following instructions explain how to properly patch a smaller crack.
When the crack is too severe on the manifold, the structural integrity is compromised. This results in the welds braking. In these circumstances, the exhaust manifold must be replaced by a professional.Learn more about Car Parts & Maintenance
White exhaust smoke is usually the result of condensation and moisture buildup in the exhaust system; it can also be the result of burning coolant within the engine. When white exhaust smoke is thin and vaporous, it usually does not signify a problem within the car.Full Answer >
The purpose of the intake manifold, or inlet manifold, is to evenly distribute the air-fuel mixture to the cylinders as well as to the carburetor on a non-fuel-injected engine. An intake manifold is the opposite of an exhaust manifold, which collects gases from the cylinders.Full Answer >
The two most common symptoms of intake manifold gaskets failing are sluggish acceleration and coolant loss. When an intake manifold gasket fails, the leak causes extra air to be sucked into the engine. This causes a decrease in gas going into the cylinders and makes the acceleration respond slowly.Full Answer >
An intake manifold runner control is an electronic system that gives data regarding linkage and plate position to the powertrain control module. The IMRC is housed inside an aluminium casting that stores a motorized actuator with air passages for each cylinder. The IMRC does not become active at engine speeds below 3,000 rotations per minute to allow its linkages to fully extend and air passages butterfly valves to close.Full Answer >