The only ways to reset the check engine light on a Dodge Neon are to use an onboard diagnostics tool or to disconnect the battery. Although disconnecting the battery resets the check engine light in most cases, most mechanics do not recommend this method for cars with anti-theft systems.Know More
Dodge Neons made through the years 2000 to 2003 allow owners to figure out the code that the check engine light is indicating without using an OBD tool. This is done by putting the key into the ignition, turning it to the accessory position and then turning it off. After repeating this three times, the check engine light starts to flash. The number of times and sequence in which it flashes indicate the check engine code. For example, if the check engine light flashes twice, pauses and then flashes once more, this indicates code 21.
The OBD is used to give mechanics and vehicle owners an inside look as to what is wrong with a car. The amount of information provided by the vehicle's self-diagnostic system has greatly improved since it was introduced in the 1980s. Some of the first systems simply illuminated specific malfunction indicators if a problem was detected, but they did not give any kind of information as to the nature of the problem.Learn more about Car Parts & Maintenance
A driver can continue operating a vehicle if the check engine light comes on and stays on, but the vehicle does not have any noticeable problems. A flashing check engine light indicates a more serious problem, and the driver should immediately pull over.Full Answer >
The best way to turn off the check engine light on a Nissan is to find out the engine code and have the problem fixed. The check engine light turns off automatically when the issue causing the light to turn on is resolved.Full Answer >
There are hundreds of reasons why a Ford Windstar's check engine light comes on, but according to AAMCO, problems with the mass air flow sensor are one of the most common. This problem usually does not cause serious problems with drivability but can decrease the vehicle's power and cause sluggish reactions. Mechanics connect a device that checks for diagnostic codes stored in the vehicle's on-board computer.Full Answer >
One of the most common reasons a check engine light comes on is a poorly secured gas cap. Gas caps should be twisted at least two full turns after they begin clicking.Full Answer >