Press the code numbers on the door of the Ford Expedition to unlock the door, and then lift the door handle to open the door. If you want to use your own code for the door, you must follow a few more steps.Know More
Press the appropriate numbers that correspond with the factory-set code for the Expedition. If you desire to continue to use the factory code, simply lift the door handle and open the door. If you want to change the code, proceed to the next step.
Push the 1-2 button on the keypad within 5 seconds after entering the factory-set code.
Type in the new 5-digit code that you would like to use to gain access to the vehicle. Make sure that each number is pressed within 5 seconds of the previous number.
Wait as the doors lock and then unlock. Once you hear this happen, this means that the personal entry code has been completed and is properly programmed. The next time that you unlock the Expedition, all you need to do is enter the 5-digit code to gain access to the vehicle.
Troubleshooting a Ford Expedition that does not start requires a systematic approach that rules out problems with the electrical system, spark and fuel before moving to issues that are more complex. The time to troubleshoot the issue depends on the cause of the failure to start.Full Answer >
A trouble or error code of P1151 on a Ford Expedition indicates an overheated exhaust oxygen sensor. This may occur because of a problem in the sensor or a problem in another system that overheats the sensor.Full Answer >
Keyless entry is a mechanism on a key ring fob that sends a signal to a car or house to lock or unlock it. It uses radio transmission to send a unique signal to a receiver located in the system it was designed to activate.Full Answer >
Code P0316 on a Ford means the power train control module detected a misfire shortly after startup. This code requires a check for appropriate technical service bulletins, as there are some bulletins that involve reprogramming the power train control module.Full Answer >