Web Results

Bolt Depot - US Recommended Bolt Torque Table


Bolt Depot - Fastener Shopping Made Easy. Your Account ... Size, Recommended Torque. Grade 2 ... are for 1-14. Grade 2, 5, and 8 values are for plated bolts.

Torque-Tension Relationship for A307A, Grade 5, 8 & 9 Bolts

www.fastenal.com/content/feds/pdf/Torque-Tension Chart for A307 Gr5 Gr8 Gr9.pdf

Caution: All material included in this chart is advisory only, and its use by anyone is voluntary. In developing this information, Fastenal has made a determined ...

Tightening Torque Guide - Alma Bolt Company & Prime Fasteners 1 ...


Tightening Torque Guide for Grade 5 & 8 Hex Cap Screws This table is based on ... This applies to washer faced or double chamfered hex nuts (or bolts, if bolt is ...

Metric Bolt Torque Table - CNCexpo.com


Metric Bolt Torque Table, torque specs estimated with clamp load as 75% of proof load as specified in ISO 898-1. Property Class: 8.8 10.9 12.9 Socket Head.

metric Torque Values - SWTC

www.swtc.edu/Ag_Power/diesel_engines/lecture/Metric torque values.pdf

tightening procedure is given for specific application. Torque values listed are for general use only. Check tightness of fasteners periodically. Shear bolts are ...

Fastener Torque Charts - Imperial Supplies LLC


Grade BD bolts. IFI-100 does not govern lock nuts above 1". The values shown in the chart are to be used as a mid- range guideline. ** Torque values for 1/4" ...

Proper Bolt Torque | zero products inc.


Many times I have been asked if a chart is published on the recommended tightening torque for various bolt grades and sizes. I do not know of any. This article ...

Torque Specification Chart - Allied Systems Company


The following torque values are to be used on all fasteners unless otherwise ... BOLT size-pitch. LUBRICATED. WITH. ANTI-SEIZE in-lbs. Nm in-lbs. Nm. 1/4”-20.

US & Metric Bolt Torque by Grade


US Bolts Maximum Torque, in foot-pounds, for clean, dry threads. Bolt size - Thread pitch, Grade 2, Grade 5, Grade 8. 1/4-20, 6, 10, 12. 1/4-28, 7, 12, 15. 5/16- 18 ...

Torquing Specification Inch & Metric Fastener Chart - Holo-Krome


Socket Head Cap Screws. Tightening. Nominal Torque (In-Pounds). 0. 1. 2. 3. 4. 5. 6. 8. 10. 1/4. 5/16. 3/8. 7/16. 1/2. 5/8. 3/4. 7/8. 1. 1-1/4. 1-1/2. -. 4.5. 7.5. 11.0.

More Info

Bolt Torque Chart - Portland Bolt


Suggested Starting Values. The below estimated torque calculations are only offered as a guide. Use of its content by anyone is the sole responsibility of that ...

Bolt Torque Chart - RepairEngineering.com


Bolt Torque Chart showing suggested torque values and corresponding bolt clamping forces for various sizes and specifications of fasteners.

Bolt Nut Recommened Torque Table for SAE Grades | Engineers Edge


This table is offered as the suggested maximum torque values for threaded products ... Bolt Size Inches, Coarse Thread/ inch, SAE 0-1-2 74,000 psi Low Carbon ...