Web Results
How to Replace a Waste Ink Absorber
Canon printers have waste ink absorbers to soak up the ink after a cleaning cycle. Printers count the number of cycles you perform and show a warning when the ink pads are getting full. The printer will quit working after enough cycles to prevent the... More »
Difficulty: Moderate
Source: www.ehow.com


Canon printers use small, spongy pads to absorb excess ink that ... When the ink absorber pads are full, you can easily remove and clean them on most Canon ...


Open the printer as though you were going to install new ink cartridges, letting the ... 2 Locate the waste ink absorbers in their black rubber.

Jan 4, 2009 ... Part 1: How to clean the waste ink absorber on the Canon Pixma iP1500. Part 2 shows you how to reset the printer: ...
Oct 28, 2008 ... How to fix the Canon Pixma iP1500 "Waste Ink Absorber Full" error - Part 2 This is part 2, I show you how to reset your printer's internal firmware ...


Mar 31, 2015 ... Locate the waste ink absorbers in their black rubber frame. They will likely be on the right side of your printer, and will be located underneath ...


Dec 2, 2012 ... When the waste ink absorber in a Canon printer gets too full, the ... You just have to remove the waste ink absorber, clean it and replace it.


The waste ink pad is a rounded piece of white foam. Pull on the waste ink pad to remove it from the printer. Be careful, because the pad will ...


When the waste ink absorber reaches capacity, the Canon Pixma IP1000 printer will no longer ... You can remove the pads and the holder with a gentle pull.