Did you mean: What Does Nerf Stand For ?
Web Results
Acronyms and Abbreviations
Search for the acronym or abbreviation:

en.wikipedia.org/wiki/Kerf_(disambiguation)

Kerf may refer to: Kerf, the width of a saw cut; Kerf, molten metal and metal oxide blown out when metal is cut by an oxy-gas torch: see Oxy-fuel welding and ...

en.wikipedia.org/wiki/Saw

A saw is a tool consisting of a tough blade, wire, or chain with a hard toothed edge. It is used to ... The kerf created by a given blade can be changed by adjusting the set of its teeth with a tool called ..... A heavier, more precise and powerful version, driven by several belts, with an enclosed base stand, is called a "cabinet saw.

www.dictionary.com/browse/kerf

Where the whole body of the tooth is bent, the saw will run smoothly and easily through the kerf and produce a smooth-cut surface. Carpentry for Boys J. S. ...

www.esabna.com/us/en/education/blog/what-is-cutting-kerf.cfm

May 19, 2013 ... Kerf Width From Plasma Gas Waterjet And Laser - Click for larger view ... Not only does kerf width vary from one process to the next, but there ...

www.definitions.net/definition/kerf

Wiktionary(0.00 / 0 votes)Rate this definition: kerf(Noun). The groove or slit created by cutting a workpiece; an incision; the width of the groove made while ...

www.abbreviations.com/KERF

Looking for the definition of KERF? Find out what is the full meaning of KERF on Abbreviations.com! 'Kath Eats Real Food' is one option -- get in to view more ...

www.merriam-webster.com/dictionary/kerf

Define kerf: a slit or notch made by a saw or cutting torch — kerf in a sentence. ... with a handsaw I made a kerf in the board to mark where I needed to cut ...

waterjets.org/archive/getting-the-most/tips/measuring-kerf-and-tool-offset

Typically, the waterjet kerf will be about 0.020″ to 0.060″ (0.5 mm to 1.5 mm), depending on the nozzle and the horsepower of the pump. There are some ...

www.wordnik.com/words/kerf

kerf: A groove or notch made by a cutting tool, such as a saw or an ax. ... By mike, November 16, 2009 @ 7:42 pm did you guys fabricate the metal dowels and kerf plates in house? Build Blog » Furniture from our ... Words That Mean Things.