Oct 31, 2012 ... Quick question on the brown wire #1 from alternator to a resistor to ... alternator
can you tell me how to hook up my wires that went to the old ...
You be the Judge! For most applications, the advantages of a THREE-WIRE
alternator will far outweigh the little time saved with a ONE-WIRE installation.
A jumper wire is supplied to connect the alternator (S) terminal to the (B+)
terminal. Refer to Fig 1 for proper wiring. If vehicle has an ignition wire, it does not
Proper installation of this alternator is the responsibility of the installer. Improper
... To install a 1-wire alternator, disconnect the positive battery cable, unbolt and ...
Convert a 2-Wire Alternator to Single Wire. ... How to Make Perfect Wire
Connections. Make Perfect Wire ... Wiring A Trail Truck Part 1 - Starter & Battery.
Wiring A ...
This diagram shows how to wire a Delco (GM) internally regulated 3-wire
alternator. This particular model (10SI, used in the 1970s and early 80s) is the
www.teamhealeytexas.com/Technical Articles/Alternator Wiring 1.htm
Alternator Wiring. All internally regulated alternators have the same basic
electrical connections. By comparing the descriptions below, it will be easy to
For example, the so-called "1-wire" alternator, even though it does indeed have
only a single wire ...
1976 Camaro three wire alternator. One of best inventions in the early 70s, is the
three wire alternator. The voltage regulator is built into the alternator.
Other than ground, there are three basic wires on an alternator : BATT, FIELD,
and SENSE. The trick is to find out which one is which, and of course, what it