Web Results

www.cisco.com/c/en/us/support/docs/dial-access/floating-static-route/118263-technote-nexthop-00.html

Sep 2, 2014 ... For example, Enhanced Interior Gateway Routing Protocol ... In order to configure a static route that is overridden by an EIGRP route, specify an ...

www.cisco.com/c/en/us/td/docs/security/asa/asa72/configuration/guide/conf_gd/ip.html

Cisco Security Appliance Command Line Configuration Guide, Version 7.2 ... This chapter describes how to configure IP routing on the security appliance.

www.cisco.com/c/en/us/td/docs/routers/access/1900/software/configuration/guide/Software_Configuration/routconf.html

Static routes provide fixed routing paths through the network. ... To configure static routes, follow these steps, ...

www.cisco.com/c/en/us/support/docs/ip/ip-routing/116264-technote-ios-00.html

Jul 10, 2013 ... Local Host Routes Installed in the Routing Table on Cisco IOS and ... are marked with an "L" in the output from the show ip route command.

www.cisco.com/c/en/us/support/docs/ip/routing-information-protocol-rip/16448-default.html

Creating a static route to network 0.0.0.0 0.0.0.0 is another way to set ... router-3# configure terminal Enter configuration ...

www.cisco.com/c/en/us/td/docs/routers/access/4400/hardware/installation/guide4400-4300/C4400_isr/initconfig.html

The setup command facility prompts you to enter the ... This section explains how to configure a hostname for the router, set passwords, and configure an interface to .... no ip routing.

www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/unicast/configuration/guide/l3_cli_nxos/l3_route.html

Feb 29, 2016 ... This chapter describes how to configure static routes on the Cisco Nexus 7000 series switches running Cisco NX-OS release 5.0(2) and later ...

www.cisco.com/c/en/us/td/docs/routers/access/2900/hardware/installation/guide/Hardware_Installation_Guide/Configure.html

The setup command facility prompts you to enter the .... ip routing ! interface GigabitEthernet0/0 shutdown ...

www.cisco.com/c/en/us/td/docs/security/asa/asa82/configuration/guide/config/route_static.html

The simplest option is to configure a default route to send all traffic to an upstream router, relying on the router to route the traffic for you. However, in some cases ...

www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/8651-21.html

Jan 2, 2008 ... The router decides whether or not to install the routes presented by the ... of each route by entering a distance after the ip route command:.